Filed Under : 
Aug.9,2011Valuable advice and general information, audits, water heater flushing and maintenance of the house is open to.
Take the water shutoff valve to prevent travel offers.
If it’s gas water heater, rinsing process in order to prevent the burner from coming across, “testing” to adjust the gas valve. Electricity, the circuit breaker to turn it off.
If the right kind of gas water heater next to the smoke you are looking at matching the lighting and make sure that air drainage. Let the smoke chimney.
Temperature of test structure. To test, place a bucket under the pipe extension, open the valve. Open water when it flows and stops when you close it. F. Set the temperature of 120 degrees recommended values
Check gas pilot light on the unit, it should be blue and stable recording. For instructions on how to relight the pilot is usually written on the side of the device.
Go back up the temperature of the flame shield and remove the burner is working OK. They burned blue and stable in order to see the flame.
Equipment at the bottom of the drain valve by connecting one end of the hose to the drain sediment from the tank and the outside or to the nearest drain in the basement to put the other end.
Security Council: Because hot water, be careful.
Turn the temperature by opening the drain valve on the device and then turn off the water supply.
Carries the lever at the top of the valve and the tank temperature / pressure to open it. Leave the faucet running.
To allow the flow of the water hose at the bottom of the heater, open the drain valve. When you run the water when rinsing is complete, the pipe is clear. Settings tab, and then close the drain valve in cold water temperature is set at the recommended temperature.
Open hot water faucet in the house until the air bubble-free run: Turn the heat back on.
Tags : 
